Stainless steel mesh belt manufacturing process and steps
May 13, 2019
1. The stainless steel mesh belt has different requirements on the material of the steel wire under different conditions. If the cooling condition only requires stainless steel mesh with satisfactory stainless steel material, it can generally choose 201 or 301. If it is high temperature resistant, the material of stainless steel mesh belt You can choose 314 or 316.
2, according to customer requirements to customize stainless steel mesh belt specifications
The time requirement for purchasing stainless steel mesh belts is to indicate the following parameters of the stainless steel mesh belt. The pitch, wire diameter, pitch, and string diameter of the stainless steel mesh belt are used to indicate the length and width of each stainless steel mesh belt accessory. Zui finally confirmed the total length of the stainless steel mesh belt.
3, stainless steel mesh belt fittings molding
The general-purpose steel wire needs to be disposed of after the material enters the factory, and the upper machine and the stainless steel mesh belt are wound and formed. The formed stainless steel mesh belt wire is cut according to the stainless steel mesh belt showing the section to ensure the width of each stainless steel mesh belt.
4, stainless steel mesh belt string
After cutting a section of the stainless steel mesh belt winding, after this, the stainless steel mesh belt was fabricated according to the customer's requirements, and the whole result type stainless steel mesh belt was wound around the string.
5, the edge treatment of stainless steel mesh belt
When the stainless steel mesh belt is wound into a series of wires, it is made into a stainless steel mesh belt. After that, it is necessary to dispose of the edge of the stainless steel mesh belt. It is considered suitable and the form used is "sintering, bending, screwing, adding chains, Chain plate, chain piece".
6, stainless steel mesh belt cleaning
Stainless steel mesh belt welding is well disposed, because the stainless steel mesh belt solder joints and the grease exposed during the winding process are deemed appropriate, and the weak alkali or weak acid is used for cleaning to treat the appearance brightness.
